Heater Assembly Replacement - Dimplex Ignite XLF50 Service Manual

Heater Assembly Replacement

Tools required: Phillips head screwdriver
Needle nosed pliers
1. Follow "Preparation for Service" instructions before
proceeding.
2. Remove the 10 screws that secure the heater assem-
bly retaining bracket to the unit. Remove the bracket
and set aside.
3. Locate and remove the 4 screws that secure the as-
sembly to the unit.
CAUTION: When removing the blower assembly
mounting screws support the assembly to prevent any
damage to the unit.
4. Disconnect the wiring connections, noting their original
locations.
!
NOTE: Using a flat head screwdriver gently pry be-
tween the end of the connectors and the blower/fan to
release the wires.
5. Properly orient the new heater assembly and connect
all of the wiring connections.
6. Secure any excess wire using the provided cable ties.
7. Reassemble in the reverse order as above.
16
Figure 10
Mounting Screws
Retaining
Bracket
www.dimplex.com