Setting The Pedal And Set Value Sensor - Dürkopp Adler 52 i-75 Series Operating Instructions Manual

Setup
Operating Instructions 52Xi, 52Xi-75 - 03.0 - 09/2023
6.6

Setting the pedal and set value sensor

Pic. 32: Setting the pedal and set value sensor
①
②
③
(1) - Pedal rod
(2) - Screw
(3) - Cross strut
1. Align the pedal (4) in such a way that the middle of the pedal
is in under the needle. The cross strut (3) has elongated holes
to allow for the alignment of the pedal.
2. Tighten the pedal (4) on the cross strut (3).
3. Attach the pedal rod (1) with the ball sockets to the set value
sensor (5) and to the pedal (4).
4. Pull the pedal rod (1) to the correct length:
Proper setting: 10° inclination with pedal (4) released.
5. Tighten the screw (2).
SWG DAC
SWG Efka
10°
④
(4) - Pedal
(5) - Set value sensor
⑤
81