Table of Contents
Advertisement
Mirrorball 10 cm
Maintenance
The operator has to make sure that safety-related and machine-technical installations are to be
inspected by an expert after every year in the course of an acceptance test.
The operator has to make sure that safety-related and machine-technical installations are to be
inspected by a skilled person once a year.
The following points have to be considered during the inspection:
01) All screws used for installing the device or parts of the device have to be tightly connected and
must not be corroded.
02) There may not be any deformations on housings, fixations and installation spots.
03) Mechanically moving parts like axles, eyes and others may not show any traces of wearing.
04) The electric power supply cables must not show any damages or material fatigue.
The Mirrorball 10 cm requires almost no maintenance. However, you should keep the unit clean.
Wipe the device with a damp cloth.
Troubleshooting
This troubleshooting guide is meant to help solve simple problems.
If a problem occurs, carry out the steps below in sequence until a solution is found. Once the unit
operates properly, do not carry out following steps.
If the mirror ball control system does not operate properly, refer servicing to a technician.
Suspect three potential problem areas as: the power supply, the motor and the mirror ball.
01) Power supply. Check if the unit is plugged into an appropriate power supply.
02) The motor. Return the motor to its dealer.
03) The mirror ball. Return the Mirrorball to your Showtec dealer.
04) If all appears to be O.K., plug the unit in again.
05) If you are unable to determine the cause of the problem, do not open the Mirrorball, as this may
damage the unit and the warranty will become void.
06) Return the device to your Showtec dealer.
Ordercode: 60413
8
Advertisement
Table of Contents
