Table of Contents
Advertisement
Mirrorball 10 cm
Installation
Remove all packing materials from the Mirrorball 10 cm. Check if all foam and plastic padding is
removed. Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Setup and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Connect the device to the main power supply.
●
Install the mirror ball in a horizontal position at a vibration-free, oscilation-free and fire-resistant
location. Use a water-level to make sure that the mirror ball is installed absolutely horizontally and
that the motor axle points are facing the bottom.
●
Perform a hazard analysis based on the location and application if the mirror ball is to be operated
above persons, in order to ensure dimensioning and measures for a safe operation. The mirror ball
meets the professional safety regulations regarding safety and operation.
●
The installation of the mirror ball has to be carried out in a way that it can hold 10 times the device's
weight for 1 hour, without any harming deformation.
●
The installation must always be secured with a safety attachment, constructed in a way that no part
of the installation can fall down if the main attachment fails.
●
When rigging, derigging or servicing the fixture, staying in the area below the installation place, on
bridges, under high working places and other endangered areas is forbidden.
●
Make sure that safety-related and machine-technical installations are approved by an expert before
taking into operation.
●
Make sure that safety-related and machine-technical installations are approved by an expert after
every four year in the course of an acceptance test.
●
Make sure that safety-related and machine-technical installations are approved by a skilled person
once a year.
Installing the Mirrorball
●
The installation materials may never include abrading material e.g. steel cables, in order to avoid
material wearing.
●
The chain must never be longer than 100 cm.
01) Connect the mirror ball chain with the screw-on chain link to the installation eye of the mirror ball
and tighten the fixation screw.
02) Insert the fourth chain link of the mirror ball chain, with the mirror ball in the screw-on chain link and
tighten the fixation screw.
Ordercode: 60413
7
Advertisement
Table of Contents
