FUTABA 3GR-2.4G Instruction Manual page 18

For NiCd battery system
- Always use an NT8F700B NiCd battery.
Charging the NiCd Battery
1
Plug the transmitter cord of the
special charger into the charg-
ing jack on the side of the trans-
mitter.
2
Plug the charger into an AC out-
let.
3
Check that the charging LED
lights.
When charging the NT8F700B NiCd battery with the special charger, allow about 15
hours for charging. If the transmitter has not been used for some time, cycle the
battery by charging and discharging it two or three times.
Over current protection
The transmitter charging circuit is equipped with an over current protection circuit. If
the battery is charged with a quick charger for other than digital proportional R/C
sets, it may not be fully charged.
18
NiCd battery
NT8F700B
Charging jack
AC outlet
Charger
Transmitter charging
LED
Cord to transmitter
charging jack