Cavity Preparation; Anti-Tip Bracket; Masonry Plug; 10X40 Cross-Head Screw - Fisher & Paykel ACTIVESMART RS9120WRJ1 Installation Manual

Internal box IMPORTANT!
The anti-tip bracket and fittings supplied must be fitted to the wall
Anti tip
of the finished enclosure to withstand 100kg load.
A
bracket kit
Ensure that anti-tip bracket is installed correctly to prevent the
appliance tipping forward when door is open.
Ensure the bracket is secured to structural beams or wall studs
nearest to the center of the alcove.

Anti-tip bracket

(1)
Attach anti-tip bracket
1
Project horizontally from the bottom edge of the finished enclosure
towards the center of the back wall.
– For 2134mm cavity installation — measure 164mm downward from the

Masonry plug

(4)
– For 2032mm cavity installation — measure 62mm downward from the
This will locate the contact surface between the bracket and appliance.

#10x40 cross-head screw

(4)
Tools
Cross-head screwdriver
2
Mark the location for placement of the anti-tip bracket. Place the bracket
so the top edge of the contact surface aligns with the mark (C).
Powered driver
3 Mark the locations of the screw holes on the wall based on the most
(with drill bit)
central wall stud (D).
4
Drill screw holes to the marked locations.
5 For wooden / p laster board wall installation:
– Fix the bracket to the wall with #10x40 pan head cross-head screws,
Pencil
6 For solid wall installation:
– Hammer masonry plugs into the wall until flush.
– Fix the bracket to the wall with #10x40 pan head cross-head screws
18
projection line (A).
projection line (B).
A
B
and screw tightly (E).
(4x), and screw tightly (F).
!3

CAVITY PREPARATION

Anti-tip
bracket
WARNING!
Read the following before fastening with masonry plugs and/or screws:
Ensure the screws avoid electrical, gas and water conduits.
Ensure lightweight masonry material such as cinder block
and new concrete (no curing time) are not used in installation.
Do not use metallic materials that may corrode, stain and/or
damage the enclosure.
E
C
D
IMPORTANT!
When positioning the appliance
in the cabinetry, ensure that the
anti-tip bracket overlaps the
refrigerator by a minimum 60mm
for a secure hold.
.
60mm overlap
Anti-tip
bracket
F
If the minimum 60mm
overlap cannot be
achieved, install a solid
spacer to the wall stud
behind the bracket.
60mm overlap
Spacer
Anti-tip
bracket