Table of Contents
Advertisement
Water fittings kit
IMPORTANT!
Ensure that the water connection is performed by a professional installer.
The product comes with a pre-connected plastic water tubing.
Water fittings are not supplied and must be purchased separately.
Ensure the appliance is connected to its own isolating switch.
Connect to water supply (Ice and Water models only)
Water tap adaptor
(1)
1
Move the appliance in front of the cabinetry close enough that you still have
access behind for power and water connections (A).
2
Insert (B) the free end of the plastic water tubing fully into a water tap
adaptor and pull (C) gently to ensure it is locked in.
Collet locking clip
(1)
3
Secure connection by inserting a locking key (D) between the water tap
adaptor and locking collet.
4
Connect the water tap adaptor to a water tap (E).
– Flush water through the hose prior to connection to the appliance
5
Turn on the water tap and check all connection are dry and free of drips.
!4
WATER AND POWER SUPPLY CONNECTION
B
C
to remove any debris in the hose.
D
A
6
Ensure there is enough tubing for the water connection and to pull
the appliance out for service, if required.
Flush water through the hose prior to connection to the product
to remove any debris in the hose.
Connect to power supply
Locate the power cord and connect the fitted plug to the electrical supply
(230VAC, 50Hz) (F). Turn ON the appliance to test if working.
– If using an isolating switch, turn OFF the appliance before continuing
the installation.
F
E
19
Advertisement
Table of Contents
