Table of Contents
Advertisement
Ice and Water display
IMPORTANT!
(Ice and Water
Failure to follow these steps can lead to difficulties in door panel adjustment and cosmetic cap fitment.
models only)
For water dispensing door panels: Remove the protective film from the appliance doors before hanging door panels.
Connect the external display module (for Ice and Water models only)
External display module
1
(1)
Remove the external display module
taped to the front of the appliance.
2
Thread the display harness through
the door panel cavity (A).
– Ensure the grommet
3
Turn the top display tabs at an
angle into the door panel (B).
– Ensure the harness is free
4
Push firmly against the bottom
display tabs and insert into the door
panel until you feel it clip securely.
– Ensure the display is flush
5
Remove water tube from the
holder on the appliance door (C).
6
Hang the door panel onto
M8 studs.
– Ensure the panel is free to
!9
DOOR PANEL INSTALLATION — STAINLESS STEEL
is engaged.
of pinching.
with the door panel.
pivot for water connections.
C
7
Connect the display harness onto the
appliance door by inserting firmly until you
feel it clip securely (D).
A
– On the external display, enable the
dispenser lock to prevent any water
from dispensing during water connection.
– To lock, press the
4 seconds. The LED above the
button will illuminate.
B
8
Push the water tube firmly into the spigot
behind the door panel until the marked line
is not visible (E).
– Ensure the water tube is routed away
from any sharp objects or corners, and
not in a location where it can be kinked
or squashed when the door panel is
secured, (as this will stop water flow).
button for
D
E
25
Advertisement
Table of Contents
