Operation - Southbend 32-40C Owner's Manual

OPERATION I"
dd
TO TURN OVEN OFF:
1. Press left side of POWER switch (3) to "OFF."
2. Turn COOK TEMP thermostat dial (2) to "OFF."
3. Turn OVEN knob (1) over oven door right to "OFF" position.
BROILER:
1. Light constant burning pilots located near front of burners.
2. Adjust pilots to approximately 314" flame length, if necessary.
3. Always check pilots to make sure they are lit before turning on main burners.
CAUTION.
FOR SAFETY REASONS, THE BROILER BURNERS SHOULD BE VISUALLY
OBSERVED FOR PROPER IGNITION
EACH
TIME THE UNIT IS PLACED IN
OPERATION. THIS SAFETY CONSIDERATION SHOULD BE OBSERVED FOR ALL
OVER-FIRED BROILER. SHOULD IGNITION FAIL AFTER 5 SECONDS, TURN
BROILER VALVE OFF AND WAIT 5 MINUTES BEFORE TRYING AGAIN.
4. Turn on the Main Burners and visually observe burner operation. The burner should have a
steady 1%" long flame.
NOTE: The front 3" of the broiler rack may be used as a holding area. This holding area is marked
by a l/8" diameter rod as shown L see Fig. 9.
-
WARMING OVEN: (32BC & 32-4OC Only)
Above this broiler is a warming oven which is heated by the flue
gases from the broiler. To use the warming oven when the broiler
is not being used is inefficient and not recommended.
STANDARD-TYPE OVEN:
1.
2.
3.
4.
5.
6.
7.
8.
Open door, raise hold-down clips and remove oven bottom
so burner is visible.
Turn oven burner to OFF.
Remove panel from spring compartment below oven door.
Depress RED button on safety valve and light pilot. New
installations may require time to bleed air from system
before pilot will become steady. The pilot flame should
impinge on the bulb to cause it to glow red. If flame is too
long and soft, bulb may be in "hollow" part of flame and
will not glow.
/
/
Hold red button allowing pilot to burn approximately 45 seconds, until tip of bulb glows red,
and then release button.
If pilot does not remain ignited, wait 5 minutes and repeat procedure.
NOTE: The lighting procedure is also printed on a plate attached to the front of the spring
compartment cover.
Once pilot holds when button is released, set thermostat dial to maximum and turn ON the oven
valve at manifold.
Burner flames should be 3/4" to 1" long.
Reduce thermostat setting slowly until bypass seat in thermostat just snaps OFF.
Immediately reverse rotation and turn dial counterclockwise until bypass snaps open.
The bypass flame should be l/8" minimum and l/4" maximum on each port.
A small fluttering bypass flame may flash back into the burner and ignite on the orifice when
the door is quickly opened and closed. This will create a carbon deposit inside the burners which
impedes proper primary air injection.
RADIANT BROILER
SECTION TWO - USER'S GUIDE
PAGE 3