Download
Share
Print this page
NCR 7746-K451 Kit Instructions
  1. Manuals
  2. Brands
  3. NCR Manuals
  4. Racks & Stands
  5. 7746-K451
  6. Kit instructions
NCR 7746-K451 Kit Instructions

NCR 7746-K451 Kit Instructions

2d scanner, back mount
Hide thumbs
1
2
3
4
5
6
7
8
9

Advertisement

Quick Links

Download this manual
Kit Instructions
2D Scanner, Back Mount
7746-K451
Issue A

Advertisement

loading
Need help?

Need help?

Do you have a question about the 7746-K451 and is the answer not in the manual?

Questions and answers

Related Manuals for NCR 7746-K451

Summary of Contents for NCR 7746-K451

  • Page 1 Kit Instructions 2D Scanner, Back Mount 7746-K451 Issue A...

  • Page 2: Revision Record

    The product described in this document is a licensed product of NCR Corporation. NCR is a registered trademark of NCR Corporation. NCR POS is a trademark of NCR Corporation in the United States and/or other countries. Other product names mentioned in this publication may be trademarks or registered trademarks of their respective companies and are hereby acknowledged.

  • Page 3: Kit Contents

    2D Scanner, Back Mount This kit provides a 2D Scanner mounted on the neck of the NCR PX10/PX15 POS (7746). Kit Contents Installation Procedure 1. Pivot the display toward the back.
  • Page 4 2D Scanner, Back Mount 2. Remove the screw (1) that secures the Front Neck Cover to the neck. Note: Use only a screwdriver with a #1 Philips bit to avoid stripping the screw head. 3. Pivot the Front Neck Cover away from the terminal. 4.
  • Page 5 2D Scanner, Back Mount 5. Remove the screws (2) that secure the Rear Base Cap to the Neck. 6. Remove the Rear Base Cap. 7. Set the terminal to stand upright, and then pivot the display toward the front.
  • Page 6 2D Scanner, Back Mount 8. Pivot the Back Neck Cover away from the terminal. 9. Slightly push the front side of the Stand Top Cover Assembly, and then pivot the cover open.
  • Page 7 2D Scanner, Back Mount 10. For versions with battery, disconnect the battery cable from the Motherboard. 11. Insert the scanner flex cable through the opening at the bottom of the neck.
  • Page 8 2D Scanner, Back Mount 12. Route the scanner flex cable through the routing slot and connect the flex cable to the Motherboard with the blue side facing the front of the terminal. 13. Position the rear scanner on the neck and pivot down. 14.
  • Page 9 2D Scanner, Back Mount 15. While holding the terminal by the neck to hold the Rear Scanner in place, install the rear base cap. 16. Install the screws (2) to secure the rear base cap on the neck. 17. Reinstall the Stand Top Cover. 18.