8.3
Version with control compulsory locking
▪
Hose connections, as described under 8.1 Make hose connections as described
under 8.1
▪
Switch off main switch
▪
Set the circuit breaker for the instantaneous water heater inside the appliance to "0".
Disconnector
Instantaneous
water heater
▪
Switch on main switch
▪
Press the "Shower water start" button and keep it pressed (button lights up) until water
flows out of the shower.
▪
Switch off main switch
▪
Set the circuit breaker for the instantaneous water heater inside the appliance to "1".
▪
Switch on main switch
8.3.1
Switching on the positive locking
▪
Connect electric cables to the Water management system and to the shower roof of
the personnel lock.
▪
Make sure that both doors to the shower room of the personnel lock are closed.
▪
Set the key switch to the "Test" position, the green buttons of the door boxes in the
personnel interlock light up. After approx. 5 seconds, switch to the "Automatic"
position, the positive locking is now activated, the green buttons on the door boxes
remain lit.
Water management system C 400 V
Original operating instructions
Put into operation
Main switch
Shower water
Start
Electrical cable
connection
to the shower roof
Key switch
25 from 40
Version 2