Advertisement
7. For LC 519AP, attach the engine cover.
Introduction
WARNING:
product, you must read and understand the
safety chapter.
Before you operate the product
1. Read the operator's manual carefully and make sure
that you understand the instructions.
2. Examine the cutting equipment to make sure that it
is correctly attached and adjusted. See
the cutting equipment on page 12 .
3. Fill the fuel tank. See
4. Fill the oil tank and do a check of the oil level. See
To do a check of the oil level on page 12 .
To fill fuel
If available, use gasoline with a low emission grade/
alkylate fuel. If gasoline with a low emission grade/
alkylate fuel is not available, use good quality unleaded
gasoline or leaded gasoline with octane number not less
than 91.
CAUTION:
octane number less than 91 RON. This can
cause damage to the product.
CAUTION:
or more frequently if it is necessary. A new
fuel filter is available at your Husqvarna
dealer.
CAUTION:
before you fill fuel.
CAUTION:
starting fluids.
1. Open the fuel tank cap slowly to release the
pressure.
8
Before you operate the
To examine
To fill fuel on page 8 .
Do not use gasoline with an
Replace the fuel filter yearly
Always stop the engine
Do not use pressurized
Operation
2. Fill slowly with a fuel can. If you spill fuel, remove it
with a cloth and let remaining fuel dry off.
3. Clean the area around the fuel tank cap.
4. Tighten the fuel tank cap fully. If the fuel tank cap is
not tightened, there is a risk of fire.
5. Move the product a minimum of 3 m / 10 ft from the
position where you filled the tank before a start.
To set the cutting height
1. Stop the engine.
2. Move the cutting height lever rearward to increase
the cutting height.
3. Move the cutting height lever forward to decrease
the cutting height.
CAUTION:
too low. The blades can hit the ground if the
surface of the lawn is not level.
Do not set the cutting height
1904 - 002 - 04.11.2022
Advertisement
