Advertisement
3. Move the throttle control to the fast speed position.
4. Hold the starter rope handle with your right hand.
5. Slowly pull out the starter rope until you feel some
resistance.
6. Pull with force to start the engine.
WARNING:
rope around your hand.
To use the drive on the wheels
•
Push the drive bail in the direction of the handlebar.
•
Release the drive bail to disengage the drive, for
example when you go near an obstacle.
•
Before you pull the product rearward, disengage the
drive and push the product forward approximately 10
cm.
To stop the product
•
To stop the engine, move the throttle control to the
stop position.
10
Do not twist the starter
•
If the engine does not stop, disconnect the ignition
cable from the spark plug.
To get a good result
•
Always use a sharp blade. A blunt blade gives an
irregular result and the cut surface of the grass
becomes yellow. A sharp blade also uses less
energy than a blunt blade.
•
Do not cut more than ⅓ of the length of the grass.
Cut first with the cutting height set high. Examine the
result and lower the cutting height to an applicable
level. If the grass is very long, drive slowly and cut 2
times if necessary.
•
Cut in different directions each time to prevent
stripes in the lawn.
•
Keep the cutting cover clean. Buildup from grass
and dirt on the inner side of the cutting cover can
decrease the cutting result. Refer to
inner surface of the cutting cover on page 11 .
To clean the
1904 - 002 - 04.11.2022
Advertisement
