Advertisement
•
Do not operate the product unless the blade and
all covers are attached correctly. An incorrectly
attached blade can come loose and cause serious
injury.
•
Make sure that the blade does not hit objects such
as stones and roots. This can do damage to the
blade and bend the engine shaft. A bent axle causes
heavy vibration and a very high risk that the blade
becomes loose.
•
If the blade hits an object or if vibrations occur,
stop the product immediately. Disconnect the ignition
cable from the spark plug. Examine the product
for damages. Repair damages or let an approved
service agent do the repair.
•
Put the product on a stable, flat surface and start it.
Make sure that the blade does not hit the ground or
other objects.
•
Always stay behind the product when you operate it.
•
Let all the wheels stay on the ground and keep 2
hands on the handle when you operate the product.
Keep your hands and feet away from the rotating
blades.
•
Do not tilt the product when the engine is started.
•
Be careful when you pull the product rearward.
•
Do not lift up the product when the engine is started.
If you must lift the product, first stop the engine and
disconnect the ignition cable from the spark plug.
•
Do not walk rearward when you operate the product.
•
Stop the engine when you move across areas
without grass, for example paths made of gravel,
stone and asphalt.
•
Do not run with the product when the engine is
started. Always walk when you operate the product.
•
Stop the engine before you change the cutting
height. Do not make adjustments with the engine
started.
•
Do not let the product stay out of view with the
engine started. Stop the engine and make sure that
the cutting equipment does not rotate.
Safety instructions for operation
Personal protective equipment
WARNING:
instructions that follow before you use the
product.
•
Personal protective equipment cannot fully prevent
injury but it decreases the degree of injury if an
accident does occur. Let your dealer help you select
the right equipment.
•
Use hearing protection if the noise level is higher
than 85 dB.
•
Use heavy-duty slip-resistant boots or shoes. Do not
use open shoes or go with bare feet.
•
Use heavy, long pants.
1904 - 002 - 04.11.2022
Read the warning
•
Use protective gloves when necessary, for example
when you attach, examine or clean the cutting
equipment.
Safety devices on the product
WARNING:
instructions that follow before you use the
product.
•
Do not use a product with defective safety devices.
•
Do a check of the safety devices regularly. If
the safety devices are defective, speak to your
Husqvarna service agent.
•
Do not make modifications on safety devices
To do a check of the cutting cover
The cutting cover decreases vibrations in the product
and decreases the risk of injury from the blade.
•
Examine the cutting cover to make sure that there
are no damages such as cracks.
To do a check of the throttle control
The throttle control stops the engine when the throttle
control is moved to the stop position.
•
Start the engine and then move the throttle control to
the stop position.
•
If the engine does not stop, do these steps:
a) Disconnect the ignition cable from the spark plug
to stop the engine.
b) Let an approved Husqvarna service agent adjust
the throttle control.
Muffler
WARNING:
hot during/after operation and at idle speed.
There is a risk of fire, especially when
you operate the product near flammable
materials and/or fumes.
WARNING:
without a muffler or with a defective
muffler. A defective muffler can increase
Read the warning
The muffler becomes very
Do not operate a product
5
Advertisement
