Advertisement
CAUTION:
with the air filter down, the engine can
become damaged.
3. Hose down the inner surface of the cutting cover
with water.
To examine the cutting equipment
WARNING:
replace immediately. Let a service agent
sharpen, replace and balance the blade.
Damaged blades and worn bolts can cause
injury and death.
WARNING:
remove the ignition cable from the spark
plug.
WARNING:
when you do maintenance on the cutting
equipment. The blades are very sharp and
injuries can easily occur.
1. Examine the cutting equipment for damage
or cracks. Always replace a damaged cutting
equipment.
2. Make sure that the engine shaft is not bent.
3. Look at the blades to see if they are damaged or
blunt.
4. Look at the blade bolts to see if they are worn or
damaged.
To do a check of the oil level
CAUTION:
damage to the engine. Do a check of the oil
level before you start the product.
1. Put the product on level ground.
2. Remove the oil tank cap with the attached dipstick.
3. Clean the oil from the dipstick.
12
If the product is put
Damaged blades must be
To prevent accidental start,
Use protective gloves
A too low oil level can do
4. Put the dipstick fully into the oil tank. Tighten the oil
tank cap to make sure to give a correct picture of the
oil level.
5. Remove the dipstick.
6. Examine the oil level on the dipstick.
7. If the oil level is low, fill with engine oil and do a
check of the oil level again.
ADD
Note:
Use a funnel to prevent spill.
To replace the engine oil
WARNING:
directly after the engine is stopped. Let the
engine become cool before you drain the
engine oil. If you spill engine oil on your skin,
clean with soap and water.
SAE 5W-30
-20
0
30
F
C
-20
-30
-10
1. Remove the ignition cable from the spark plug.
2. Remove the oil tank cap.
3. Drain the engine oil.
a) For models with an oil drain plug: Put a container
below the oil drain plug, to collect the engine oil
in.
b) For models without an oil drain plug or if it is not
possible to put a container below the oil drain
plug: Use an oil pump (accessory) to drain the
engine oil from the oil tank.
4. Fill with new engine oil of the type recommended in .
5. Do a check of the oil level. Refer to
the oil level on page 12 .
Air filter
An air filter that is used for a long time cannot be fully
cleaned. Replace the air filter at regular intervals.
CAUTION - DO
FULL
Engine oil is very hot
SAE 30
SAE 10W-30
32
40
100
60
80
0
10
20
30
To do a check of
1904 - 002 - 04.11.2022
01341
40
Advertisement
