Wilson Electronics WILSONPRO ENTERPRISE 4300R Installation Manual page 36

In-building cell signal amplifier with multi-tower targeting (mtt) technology

Hide thumbs Also See for WILSONPRO ENTERPRISE 4300R:

Table of Contents

Local Ampliﬁer

Conﬁguration Utility

If you need to modify the ampliﬁer communication settings, this utility was created to

help you. The default setting is Ethernet Preferred (gives priority to Ethernet, but will

switch to LTE if Ethernet is not connected).

NOTE: It is only necessary to use this utility if you wish to CHANGE a communication

setting. The default setting of Ethernet preferred, LTE backup, is almost always the

best setting to use.

Cat 5/6 cable

IN-BUILDING CELL SIGNAL AMPLIFIER

If the Installer/Integrator wishes

to change this setting, a laptop

computer must be connected to the

4300/4300R via a Cat 5/6 cable to

the Ethernet port on the ampliﬁer.

After connecting, the network icon on

the ampliﬁer will change color from red

to yellow after about one minute.

ENTERPRISE 4300 & 4300R

Table of Contents

Wilsonpro enterprise 4300