11 SERVICE WORK ON THE CHASSIS
11.13
11.14
11.15
11.16
52
Lubricating the steering head bearing
H02387-01
Removing the start number plate
S03018-10
Installing the start number plate
S03019-10
Removing front fender
–
Remove the lower triple clamp.
–
Install the lower triple clamp.
Info
The steering head bearing is cleaned and lubricated
in the course of removal and installation of the lower
triple clamp.
–
1
Remove screw
. Swivel the start number plate to one side.
–
2
Remove screw
and take off the brake line guide and start
number plate.
–
Position the brake line and brake line guide on the start num-
ber plate.
–
Mount and tighten screw
–
Position the start number plate.
The holding lugs engage in the fender.
–
Mount and tighten screw
Guideline
Remaining screws,
chassis
Preparatory work
–
Remove the start number plate. (
(
p. 47)
(
p. 48)
1
.
2
.
M6
10 Nm (7.4 lbf ft)
p. 52)