Operation Flow By The System Menu - Omron NT20S-ST121B-EV3 User Manual

Operation Flow by the System Menu

3-1

Operation Flow by the System Menu

Create the Screen Data
Start Up the NT20 (Display the System Menu.) (page 84)
Initializing Memory (page 88)
Memory Switch Settings (page 91)
Registering the Screen Data (page 102)
Starting the Operation
(page 105)
System Maintenance (page 115)
82
Follow the procedure below when using the NT20 for the first time or when
changing the system.
Create the screen data to be displayed on the NT20 by using the Support
Tool.
For the screen data creation, refer to the "NT Support Tool for Windows Oper-
ation Manual" (V061-E1-@).
Turn ON the power to the NT20.
When no screen data has been registered, the "SYSTEM MENU" will be dis-
played. If the NT20 enters the RUN mode, press appropriate touch switches
to display the System Menu.
Select a System Menu and initialize the NT20 unit memory.
Select the System Menu and make settings such as the communications con-
ditions for communications with the Host by setting the memory switches.
Connect the Support Tool to the NT20 and transfer the screen data from the
Support Tool to the NT20.
For the connection of the Support Tool, refer to 2-4 Connecting the NT Sup-
port Tool on page 35.
Connect to the PLC/Host and start the operation.
If an error has occurred during operation, check the I/Os, settings, etc. refer-
ring to this guide.
Section 3-1