netvox R718N360 User Manual page 13

1. The Wireless 3-Phase Current Meter Interface has a
built-in magnet (as the Figure 1 below). It can be attached
to the surface of an object with iron during installation,
which is convenient and quick.
To make the installation more secure, please use screws
(purchased separately) to fix the device to the wall or other
objects (such as the installation diagram).
Note: Do not install the device in a metal shielded box or in
an environment surrounded by other electrical equipment to
avoid affecting the wireless transmission of the device.
The Wireless 3-Phase Current Meter Interface is suitable for the following scenarios:
⚫ School
⚫ Factory
⚫ The mall
⚫ Office building
⚫ Smart building
Where the electrical data of the equipment with the three-phase electricity needs to be detected.
2. The Wireless 3-Phase Current Meter Interface
(R718N360) samples the current according to MinTime.
If the current value sampled this time relatively exceeds the
set value (the default is 100mA) more than the current value
reported last time, the device will immediately report the
current value sampled this time. If the current variation does
not exceed the default value, the data will be reported
regularly according to MaxTime.
Press the [Function Key] of the device to start sampling data
and report the data after 3 to 5 seconds.
Note:
MaxTime must be set greater than Min Time.
12