Advertisement
Step 2
Fasten the LEFT RAIL (1) and one of the SMALL
å
EXTENSION BLOCKS (M) to the LEFT UPRIGHT (H)
exactly as shown. Use two BLACK 11/16" FLAT
HEAD SCREWS (16).
NOTE: Find the back hole fi rst. Then, slide the inner
å
cartridge of the LEFT RAIL in to fi nd the other hole that
lines up with the hole in the SMALL EXTENSION BLOCK
and LEFT UPRIGHT. Turn a SCREW into this hole.
NOTE: You should start each SCREW a few turns before
å
completely tightening any of them.
BLACK 11/16" FLAT HEAD SCREW
(2 used in this step)
These edges
should be even.
Line up the
back hole fi rst.
Page 6
16
Holes facing up
1
M
H
Finished surface
1
This hole is closer
to this edge.
Advertisement
