J5 Axis Origin Setting - Mitsubishi RV-6S Series Instruction Manual

(5) J5 axis origin setting

<TOOL> 12345678
BRAKE (00000000)
SET AXIS(11110000)
ORIGIN :NOT DEF
Designate the origin setting axis
Pinhole (J5 axis)
Move the cursor
<TOOL> 12345678
BRAKE (00000000)
SET AXIS (00001000)
ORIGIN :NOT DEF
Designate the origin setting axis
<TOOL>
SET ORIGIN
OK?(1)
1:EXECUTE
Set the origin
<TOOL> 12345678
BRAKE (00000000)
0
SET AXIS (000 1000)
ORIGIN :COMPLETED
◇◆◇ Origin setting axis designation ◇◆◇
Move the cursor to the "SET AXIS" axis No. in the origin setting with the [ ← ] or [ → ] key.
The origin is set only for the axis for which a "1" is displayed on the screen. If the origin is not to be set, press
the [0] key and display a "0".
-B
(J5)
1
DEF
RPL
↓
INP
-B -C
・
→
(J5) (J6)
EXE
1 0
DEF ABC
INP
-B
→
(J5)
EXE
1
DEF
Get other manuals https://www.bkmanuals.com
5Maintenance and Inspection
1) Slowly rotate the J5 axis in the direction of plus
90° with both hands. Align the pinholes of the
No. 2 arm and wrist housing , feed through the
origin jig (φ6) into the pinholes and fasten.
2) Press the [ ↓ ] key. The cursor will move to
"SET AXIS".
3) Designate the axis for which the origin is to be
set.. Set "1" for the 5 axis, and set "0" for the
other axes. Then, press [INP] key. Next, a
confirmation screen will appear.
4) Press the [1] and [INP] keys.
The origin posture will be set.
5) Setting of the origin is completed.
6) Refer to "5.5.4Recording the origin data" on
page 65 in this manual, and record the origin data
on the origin data seal.
Resetting the origin 5-59