FAN mode
For simply recirculating air, choose the Fan mode "
button "
".
Note: Temperature button is invalid in Fan only mode.
HEAT mode
Cycle mode button to highlight the sun icon "
Select desired set point temperature by pressing the plus or minus keys
After a short delay the compressor will start. However, air will not begin to flow until it has been heated up
sufficiently; this is to prevent cold draft.
DRY mode
The Dry mode is used when the room temperature is close to comfortable but you wish to dehumidify the air.
Cycle mode button to highlight the snowflake/dripping icon "
Select desired set point temperature by pressing the plus or minus keys "
locked in LOW.
The compressor will cycle on and off to extract moisture from the air.
AUTO mode
The Auto mode "
Press MODE until AUTO is displayed in the Mode Display.
Press FAN SPEED until the required speed is selected .
Select desired set point temperature by pressing the plus or minus keys "
SLEEP
With the unit operating in cool mode, press "
icon). The unit will automatically raise the set point by 1 ˚C per hour for the next three hours. Conversely in heat
mode, the set point will be lowered by 1˚C.
Note: Sleep mode will automatically be can celled in 8 hours.
BUTTON LOCK
This provides a means of locking the mode and fan settings to prevent any unintended input.
Press "
" and "
"
" will display when button locked. Note: On/Off "
Celsius and Fahrenheit degree change
Press "
" and "
" is used when Turn unit ON.
" for 3 seconds to activate button lock, to unlock repeat the procedure.
" for 5 seconds to change temperature measurement unit to either ℃ or ℉
". Choose any of the three fan speeds by pressing the fan
".
"
".
" and "
" for 3 seconds to highlight the sleep light (moon
" will not be affected by the button lock.
16
" or "
"
.
" or "
". Note: the fan speed is
" or "
".
.