Nav/Com/Transponder/Audio Panel; Com Operation - Garmin Beechcraft 200 Series Cockpit Reference Manual

NAV/COM/TRANSPONDER/AUDIO PANEL

COM OPERATION

Manually tuning a COM frequency:
1) Turn the COM Knob to tune the desired frequency (large knob for MHz;
small knob for kHz).
2) Press the Frequency Transfer Key to transfer the frequency to the active field.
3) Adjust the volume level with the COM VOL/SQ Knob
4) Press the COM VOL/SQ Knob to turn automatic squelch on and off.
Manual COM frequency tuning from the PFD/MFD Controller
1) Press the COM Key to enable the FMS Knob for COM tuning. The COM
Tuning Selection Box is shown.
2) Press the COM Key again, if needed, to select the desired COM radio (1 or
2).
3) Turn the FMS Knob to tune the desired frequency in the COM Tuning Box
(large knob for MHz; small knob for kHz).
Or:
Press the numeric keys on the keypad to enter a Frequency.
4) Press the Frequency Transfer Key to transfer the frequency to the active field.
Auto-tuning a COM frequency for a nearby airport from the PFD:
1) Press the Nearest Softkey on the PFD to open the Nearest Airports Window.
A list of 25 nearest airport identifiers and COM frequencies is displayed.
2) Turn the FMS Knob to scroll through the list and highlight the desired COM
frequency.
3) Press the ENT Key to load the COM frequency into the COM Standby
Frequency Field.
4) Press the Frequency Transfer Key to transfer the frequency to the COM
Active Frequency Field.
Auto-tuning a COM frequency from the WPT and NRST Pages:
1) From any page that the COM frequency can be auto-tuned, activate the
cursor by pressing the FMS Knob or pressing the appropriate softkey.
2) Turn the FMS Knob to place the cursor on the desired COM frequency.
190-02040-01 Rev. B Garmin G1000 NXi Cockpit Reference Guide for the Beechcraft 200/B200 Series
Nav/Com/XPDR/Audio Panel
.
15