Additional Weather Radar Displays - Garmin Beechcraft 200 Series Cockpit Reference Manual

Hide thumbs Also See for Beechcraft 200 Series:
Table of Contents

Advertisement

Hazard Avoidance

ADDITIONAL WEATHER RADAR DISPLAYS

Enabling/disabling Airborne Weather Radar Overlay on the 'Map -
Navigation Map' Page:
1) Select the 'Map- Navigation Map' Page.
2) Select the Map Opt Softkey.
3) Select the WX Radar Softkey.
Adjusting the bearing and antenna tilt angle on the 'Map - Naviga-
tion Map' Page:
1) With the weather radar overlay enabled, push the Joystick twice. The
bearing and tilt legend is displayed.
2) Move the Joystick up to adjust the antenna tilt angle downward, or move
the Joystick up to adjust the antenna tilt angle upward.
3) Move the Joystick left or right to adjust the bearing line in the desired
direction. The bearing line is displayed during and momentarily after
adjustment.
Controlling of weather radar information on the HSI Map (GWX-
70/75):
1) If necessary, enable the HSI Map on the PFD.
2) On the PFD, press the Map/HSI Softkey.
3) Press the Wx Radar Softkey to enable/disable the airborne weather radar
HSI Map overlay.
4) Press the RDR Opt Softkey.
5) To select a weather radar mode, press the Mode SEL Softkey
a) Press a softkey for the desired mode: Standby, Weather, or Ground.
b) When finished, press the Back Softkey.
6) Press the Gain- Softkey to decrease the gain setting or press the Gain+
Softkey to increase the gain setting in increments of 0.5 with each press, or
press and hold the softkey for continuous adjustment. A gain setting of 0.0
is equivalent to the calibrated gain setting.
116
Garmin G1000 NXi Cockpit Reference Guide for the Beechcraft 200/B200 Series
190-02040-01 Rev. B

Advertisement

Table of Contents
loading

This manual is also suitable for:

Beechcraft b200 seriesG1000 nxi

Table of Contents