Procedure; No Parts Required - Toro 79487 Manual

1
Preparing the Machine

No Parts Required

Procedure

Note:
Determine the left and right sides of the
machine from the normal operating position.
1. Park the machine on a level surface.
2. Disengage the blade-control switch.
3. Move the motion-control levers outward to the
P position.
ARK
4. Shut off the machine and remove the key.
5. Wait for all moving parts to stop.
6. Allow machine components to cool.
7. Non-MyRide models only: Raise the seat;
refer to your machine Operator's Manual.
8. MyRide models only: Perform the following
steps to remove the seat.
A. Use the seat position lever to slide the seat
forwards and backwards
B. Access the 4 Torx bolts that secure the seat
pan to the frame. Remove the bolts, then
carefully remove and set aside the seat
assembly (Figure
(Figure 1).
Figure 1
2).
1. Torx bolt
9. Raise the rear of the machine on jack stands;
refer to your machine Operator's Manual.
WARNING
Supporting the machine on the lower
muffler shield
the shield and cause the machine to fall,
injuring you or bystanders.
Do not use the lower muffler shield to
support the machine.
g471967
10. Remove the rear tires as shown in
3
Figure 2
2. Seat assembly
(Figure 3) may damage
Figure 3
Figure 4
g471954
g471762