1. Sail area of blade
2. Blade
3. Curved washer
3
Removing the Existing Baffle
No Parts Required
Procedure
1. Remove the flange nuts holding the baffle in place
(Figure
3).
2. Remove the bolts holding the baffle in place
3. Remove the baffle and replace the nuts and bolts in the
holes for the baffle
4. Remove the hardware as indicated in
the hardware.
Note: Save the baffle and hardware for use when changing
to side-discharging mode.
1
2
g017443
(Figure
(Figure
3).
Figure
3. Save
3
4
Figure 2
4. Blade bolt
5. Spindle-shaft end (hex end shown)
3).
1. Bolts
2. Baffle
4
5
Figure 3
3. Nuts
4. Remove the hardware
before installing the
baffles.