Table of Contents
Advertisement
BXTR5224
Wood Chipper
6.3 Maintenance Schedule
Perform maintenance procedures at time shown or hour
interval, whichever comes first.
As Required
Check the condition of all hydraulic lines, hoses and fittings. Replace
any that are damaged.
Visually check drive belt tension.
Remove entangled material from chipper.
Check that all fasteners are tight. Check wheel lug torque. See page
62.
Every 8 hours or Daily
Check engine oil level.
Check hydraulic fluid level.
Perform Pre-start checks
Every 50 hours or Annually
Clean engine air filter
Check drive belt tension and sheave
alignment
Check rotor blade sharpness.
Inspect hydraulic fluid quality
Inspect battery
Check ledger knife sharpness
Check twig breaker
Grease entire machine
Every 100 hours or Annually
Change engine oil
Check tire pressure
Change hydraulic fluid filter
Change engine air filter
Clean machine. Remove debris and
entangled material.
Change fuel filter
See page 36
See page 36
See page 34
See page 50
See page 53
See page 54
See page 36
See page 51
See page 55
See page 57
See page 46
See engine manual
See rating on tire sidewall
See page 50
See page 50
—
See page 57
45
Service and Maintenance
Advertisement
Table of Contents
