Maintenance Schedule; Grease Points - Wallenstein BXS Series Operator's Manual

BXS Series
3PH Self-feed Chipper

8.2 Maintenance Schedule

Perform maintenance procedures at time shown or hour interval,
whichever comes first.
As required
Remove entangled material from chipper.
Lubricate hinges and pivot points.
Every 8 hours or daily
Grease PTO Shaft
Perform Pre-operation check
Every 50 hours or annually
Check rotor blade sharpness
Check ledger knife sharpness
Check twig breaker
Grease entire machine
Every 100 hours or annually
Wash and clean wood chipper. Remove entangled material, wood
chips, small debris.

8.3 Grease Points

IMPORTANT! Use a hand-held grease gun for all greasing.
Pump one shot of grease per fitting.
See this page, and page
35
See page 27
See page 36
See page 7
See page 35
See page 34
33
• Wipe grease fitting with a clean cloth before greasing to
avoid injecting dirt and grit.
• If fittings do not take grease, remove and clean them
thoroughly. Replace grease fittings as necessary.
Location Every 8 hours of operation
1 PTO Shaft Universal Joints
2 PTO Shaft Slip Joint
1
Fig. 36 – 8-hour Grease Points
Service and Maintenance
1
2
01367