Table of Contents
Advertisement
Service and Maintenance
7.3 Maintenance Schedule
Perform maintenance procedures at time shown or hour
interval, whichever comes first.
As Required
Check the condition of all hydraulic lines, hoses and fittings. Replace
any that are damaged.
Remove entangled material from chipper.
Lubricate hinges and pivot points.
Every 8 hours or Daily
Grease PTO Shaft
Check hydraulic oil level
Perform Pre-operation check
Every 50 hours or Annually
Check rotor blade sharpness
Check ledger knife sharpness
Check twig breaker
Grease entire machine
See this page, and page
56
See page 42
See page 56
See page 57
See page 56
See page 51
52
7.4 Grease Points
IMPORTANT! Use a hand-held grease gun for all greasing.
Pump one shot of grease per fitting.
• Wipe grease fitting with a clean cloth before greasing to
avoid injecting dirt and grit.
• If fittings do not take grease, remove and clean them
thoroughly. Replace grease fittings as necessary.
Location
– Every 8 hours of operation
1
PTO Shaft Universal Joints
2
PTO Shaft Slip Joint
1
Fig. 66 – 8-hour Grease Points
BX52R, BX72R, BX102R
3 PH Roller-feed Chipper
Grease Points
1
2
00867
Advertisement
Table of Contents
