JVC GY-HC900CHE Instructions Manual page 148

o Adaptive Bit Rate
If "On" is selected, the bit rate setting value of live
streaming is set to maximum limit, and the bit rate
is changed automatically according to changes in
the network bandwidth.
[Setting Values: On, ROff]
Memo :
[Adaptive Bit Rate] can be configured when
0
[Type] is configured to "ZIXI" or "SRT".
* The bit rate is displayed on the status screen
only when "On" is set.
o SMPTE 2022-1 FEC
Set to "On" to use FEC (Forward Error Correction).
A transmission system that recovers the missing
packets in the decoding process without having to
retransmit the missing packets.
[Setting Values: On, ROff]
* The decoder must be compatible with SMPTE
2022-1.
Memo :
This item is selectable only when [Type] is set to
0
"MPEG2-TS/RTP".
o FEC Matrix
For setting the amount of FEC (Forward Error
Correction) overhead for configuring
SMPTE2022-1.
(A P226 [Setting the FEC Matrix] )
Memo :
This item is selectable only when [SMPTE
0
2022-1 FEC] is set to "On".
o Bandwidth Overhead
Enter the SRT bandwidth overhead using an
integer between 5% and 100%.
The default value is "25%".
Memo :
This item is selectable only when [Type] is set to
0
"SRT".
148
Network Menu
o Latency
Enter the amount of SRT latency using an integer
between 20 ms and 8000 ms.
The default value is "500ms".
Memo :
This item is selectable only when [Type] is set to
0
"SRT".
o Encryption
For configuring the SRT encryption mode.
[Setting Values: AES-256, AES-192, AES-128,
ROff]
Memo :
This item is selectable only when [Type] is set to
0
"SRT".
o Passphrase
For configuring the SRT passphrase.
You can enter a passphrase between 10 to 79
characters. The default passphrase is generated
randomly.
Memo :
This item is selectable only when [Type] is set to
0
"SRT".
The passphrase can be configured when
0
[Encryption] is configured to a setting other than
"Off".
o FEC
For configuring the FEC mode.
It enables recovery of data streaming packet loss
without retransmission.
[Setting Values: 6x6, 8x8, 10x10, ROff]
Memo :
This item is selectable only when [Type] is set to
0
"SRT".