Setting Time Code Generator - JVC GY-HC900CHE Instructions Manual

Time Code Operation Mode
Select the time code operation using the [TC
GEN] switch.
Setting
F-RUN The time code operates in the run
mode at all times regardless of the
recording status.
It continues to run even when the
power of the camera recorder is
turned off.
Synchronizes with the external
time code when an external time
code generator is connected.
(A P80 [Synchronizing the
Time Code with an External
Time Code Generator] )
R-RUN The time code operates in the run
mode during recording. It
continues to run in the order of the
recorded clips as long as the SD
card is not replaced. If the SD card
is removed and recording is made
on another card, time code will be
recorded on the new card from
where it was left off in the previous
card.
REGEN The time code operates in the run
mode during recording. When the
SD card is replaced, the last time
code recorded on the card is read
and recorded on a new card so that
the time code continues in running
order.
(A P77 [Setting Time Code] )
Memo :
When [System] B [Record Set] B [Rec Mode] is
0
set to "Interval Rec" or "Frame Rec", and the [TC
GEN] switch is set to "F-RUN", R-RUN mode is
activated.
When [System] B [Record Set] B [Record
0
Format] B [System] is set to "High-Speed", and
the [TC GEN] switch is set to "F-RUN", R-RUN
mode is activated.
76
Time Code and User's Bit
Description
Setting Time Code
Generator
Presetting the Time Code
Time code and user's bit data generated from the
internal time code generator are recorded.
This section describes how to set [TC/UB] B [TC
Preset].
(A P126 [ TC Preset ] )
Memo :
When [System] B [Record Set] B [Record
0
Format] B [WFrame Rate] is set to "50p", "50i"
or "25p", setting for "Drop" will be disabled.
(A P161 [WFrame Rate/
You can configure the setting without accessing
0
the [TC/UB] menu screen.
(A P78 [Setting Time Code without Opening
the Menu] )
Required Settings Before Preset
.
1 Set the [TC GEN] switch to "R-RUN" or "F-
RUN".
[R-RUN]
0
Preset data in the time code generator
operates in run mode during recording mode.
Set this when recording continuous time
code in connecting frames.
[F-RUN]
0
Time code starts to operate in run mode from
the preset time in the time code generator.
Frame Rate] )
PRESET
GEN
F-RUN
R-RUN
REGEN
DISPLAY
TC
UB