JVC GY-HC900CHE Instructions Manual page 150

9 Server1, Server2, Server3, Server4
* The name that is set in [Alias] is displayed
individually.
o Alias
For setting a name to distinguish the settings of this
camera.
The name set in this item will be displayed in the
[Server] options.
*1 The default value is "Server1/Server2/
Server3/Server4".
*2 You can enter up to 31 characters and ASCII
characters.
o Type
For configuring the system for transferring video
and audio to be distributed.
[Setting Values: RRTSP/RTP, ZIXI(SRT), Icecast]
Memo :
Operates as IFB when the setting is configured
0
to "Icecast".
Use transmission devices that are compatible
0
with the respective transfer systems.
To use the "ZIXI" setting, a dedicated server is
0
needed separately.
SRT protocol update needs to be performed
0
before using the SRT protocol. Doing so will
make the Zixi protocol unusable.
To enable the use of the Zixi protocol again,
perform Zixi protocol update.
The following items that can be set vary
0
depending on the setting of this item.
o Protocol
For configuring the protocol of the video/audio
source server to be connected.
[Setting Values: RUDP, TCP]
Memo :
This item is selectable only when [Type] is set to
0
"RTSP/RTP".
o Connection Mode
For configuring the SRT connection mode.
[Setting Values: RCaller, Listener, Rendezvous]
Memo :
This item is selectable only when [Type] is set to
0
"SRT".
150
Network Menu
o Source Address
For configuring details such as the host name and
IP address of the video/audio transmission source.
There is no default value (blank).
*1 A maximum of 191 ASCII characters can be
entered when [Type] is configured to a setting
other than "SRT".
*2 A maximum of 191 characters including
single-byte alphanumeric characters (a to z, 0
to 9) and single-byte hyphen [-] and dot [.] can
be entered when [Type] is configured to
"SRT".
o Source Port
Enter the network port number of the video/audio
transmission source using an integer between 1
and 65535.
The default value is "554" when [Type] is set to
"RTSP/RTP", "2077" when it is set to "ZIXI", and
"5000" when it is set to Icecast.
Memo :
When [Type] is set to "RTSP/RTP", only even
0
numbers from 2 to 65530 can be specified for
the port number.
o Port
Enter a SRT port number using an integer between
1 and 65535.
The default value is "6510".
Memo :
This item is selectable only when [Type] is set to
0
"SRT".
o Stream ID
For configuring the stream ID registered on the
video/audio transmission source.
There is no default value (blank).
* Enter not more than 63 characters.
Memo :
This item is available for setting when [Type] is
0
set to "RTSP/RTP" or "ZIXI".
o Username
For setting the user name.
There is no default value (blank).
* Enter not more than 63 characters.
Memo :
This item is selectable only when [Type] is set to
0
"RTSP/RTP".