JVC GY-HC900CHE Instructions Manual page 101

Time Code Playback
Time code or user's bit recorded on an SD card can
be displayed on the LCD monitor and viewfinder.
Memo :
The time code is also superimposed on the
0
video signal output from the [HD/SD SDI OUT
1/2] terminal.
If a section without time code is played back, the
0
time code will stop. However, playback will
continue.
Displaying Information during Shooting
Pressing the [DISPLAY] button during playback
displays the display screen.
Pressing the [USER4] button during shooting
switches the display information between camera
information display, GPS display and turning off the
display.
The GPS display displays information on the
0
recording location of the video being played
back only when GPS information has been
recorded.
Camera information display displays only
0
information of Gain, Iris, Shutter and White
Balance that have been recorded.
Display Off
+139.652172
USER4
GPS Display
.
Memo :
Trimming information is displayed while
0
trimming is in progress. In this case, pressing the
[USER4] button does not switch the display.
0
dB
F1. 6
1/ 100
5600K
USER4
Camera Information Display
USER4
+35.483197
Playing Recorded Clips
101