Table of Contents
Advertisement
When remote maintenance access is enabled using function code *754, access will
automatically be barred again once the remote maintenance process has been com-
pleted. It is possible to bar remote maintenance manually using #754 before it is initi-
ated.
Remote maintenance access can be enabled permanently using the function code
*753. To bar access, the authorized user must enter the function code #753 manually.
The enabling or barring of remote maintenance access using the function code is sig-
nalled in each case by an acknowledgement tone.
Remote maintenance access can also be enabled or barred in WebAdmin, if the rele-
vant authorization has been given.
Note:
In a QSIG network it is important to ensure that the authorization to change the remote mainte-
nance access is also denied to unauthorized PISN users. Otherwise, a PISN user would be
able to use an abbreviated dialling number defined for the destination PINX and containing the
appropriate function code to change the remote maintenance access to the destination PINX.
Mitel Advanced Intelligent Network:
In an AIN the remote maintenance access of all the nodes depends on the setting in the Master.
If remote maintenance access is enabled in the Master, both the AIN configuration and the
offline configuration of the satellites are enabled.
Remote maintenance access via an external dial-up connection to the AIN is also secured and
has to be explicitly enabled (see "Enabling / disabling the dial-up connection to the AIN",
page 207). This is irrespective of whether dial-up access is via a satellite or directly to the Mas-
ter.
5. 4. 3
Function keys for remote maintenance access
On system phones the function code for enabling/barring remote maintenance access
can be stored under a function key, provided the user has the appropriate authoriza-
tion.
The relevant LED lights up if remote maintenance access is enabled once or perma-
nently.
The relevant LED goes off as soon as remote maintenance access is denied again, ei-
ther automatically or manually, using the function code or WebAdmin.
5. 5
Configuring with WebAdmin
The configuration steps are based on the information determined during the planning
and, where applicable, the installation.
Whenever possible, use the planning and ordering software Mitel CPQ, to set up your
communication system. Mitel CPQ can be operated online after logging in at
Mitel 415/430
syd-0580/2.1 – R6.1 – 06.2019
Configuration
171
Advertisement
Table of Contents
