Installation Guide - Maytronics Ozone Swim Twin Series User Manual

Installation Guide

1200i control units
These products must be installed by a qualified installer
from
PUMP
pool
Note: Install the Ozone Swim control unit a minimum of 900mm above ground level in an area
protected from the elements to eliminate possible damage from severe weather conditions.
Step 1:
Mount Ozone Swim control unit a maximum of 1.5 metres from the filter. Fit two screws into
control unit wall bracket and hang control unit.
Step 2:
Plumb ozone injection manifold after chlorine cell on the return to the pool; ensuring the
direction of the ozone injection manifold is correct (arrow indicated direction of water flow).
The manifold should be last on the return line, after all other equipment is installed.
Step 3:
Leave plumbing to cure for a 24 hour period for best results.
Step 4:
Connect supplied Teflon tubing onto the ozone injection manifold stainless steel fittings and the
Ozone Swim Control Unit stainless steel fittings by simply screwing on each end. (Do not over
tighten). See label on Teflon tubing to ensure the correct stainless steel fitting is on the injection
manifold and control unit which ensures correct direction of check valve.
Step 5:
Plug the Ozone Swim power cord into chemical system (salt chlorinator / dosing system). Pool
pump can be plugged into the under casing of Ozone Swim control unit. Switch unit on. The
ozone unit will be controlled by the existing Chlorinator / Chemical controller.
Note: If using a chlorinator, always ensure your pump is running, never allow your chlorinator to
operate without the pump running.
CHLORINATOR
MEDIA FILTER
CELL
VENTURI
return
to pool
CONTROL UNIT
U s e r M a n U a l 9