Advertisement
Advertisement
Table of Contents
Related Manuals for Maytronics OzoneSwim 1200i
Summary of Contents for Maytronics OzoneSwim 1200i
- Page 1 1 2 0 0 i + 10 0 0, 2 00 0, 3000 USER MANUAL...
-
Page 2: Important Safety Information
For installations where the filter/chlorination system is below the level of the pool, a drain valve must be fitted to keep the ozone outlet line dry should any water backflow through the line. This drain valve is available from Maytronics. U s e r M a n U a l... -
Page 3: Table Of Contents
Notice of Liability: While every effort Maintenance ......................21 has been taken to ensure the accuracy of this document, neither Maytronics Australia nor any of its official representative shall have any liability to any person or entity with Water Chemistry (Balancing Information) .......... -
Page 4: Control Unit Features
1000, 2000, 3000 units Control Unit Features 1200i unit Ozone Run Indicator Air Filter Chlorine Cell Output Display Ozone Output Ozone Run Indicator Ozone Output Fuse Positive Cell Lead (Red) Fuse Positive Cell Lead (Red) Master Switch Negative Cell Lead (Black) Master Switch Negative Cell Lead (Black) Sanitation Switch... -
Page 5: Installation
Installation Guide 1200i control units These products must be installed by a qualified installer CONTROL UNIT CHLORINATOR CELL MEDIA FILTER INJECTION MANIFOLD from PUMP pool return to pool Note: Install the Ozone Swim control unit a minimum of 900mm above ground level in an area protected from the elements to eliminate possible damage from severe weather conditions. - Page 6 1000, 2000, 3000 control units These products must be installed by a qualified installer Step 4: Connect the chlorine cell cable to the three colour coded terminals located on chlorine cell. (Terminals need to be slightly crimped for snug fit). CONTROL UNIT Step 5: CHLORINATOR...
-
Page 7: Important Notes
Important Notes Pump Outlet Socket Chlorinator Cell Housing Installation A 240 volt pump output power socket is supplied and located on the left- hand underside of the Ozone Swim control unit. Your pool pump power The Ozone Swim cell housing must be plumbed into the return line of the supply lead should be plugged into the socket so that when the time clock switches at the designated times both the Ozone Swim and the pump will pool filter system after the filter and any diversion valves. -
Page 8: Operations
Flooded Installation* For installations where control box is below water level POOL from CHLORINATOR filter CELL CONTROL UNIT If water level is above the INJECTION OzoneSwim control unit, a MANIFOLD drain valve must be fitted. DRAIN VALVE return to pool * Diagram is for illustration purposes only. -
Page 9: Operating Instructions
By adjusting the c • It is essential that the new pool is balanced correctly. Consult your 15-minute intervals. pool builder on how do this or Maytronics can provide information to increase chlorine production and by turning anti do this. - Page 10 Checking Chlorination Output Chlorine Cell Output Display Definitions (1000, 2000 & 3000 series only) The chlorine cell output controller regulates the amount of chlorine production relevant to the position it has been set to. By adjusting the Your Ozone Swim unit is fitted with a digital display. During operation of cell output controller clockwise, you increase chlorine production and by your Ozone Swim unit the display will illuminate relevant to the degree at turning anti clockwise you reduce production.
-
Page 11: Maintenance
Maintenance Replace the check valve in the Ozone Every 12 months or as required The Teflon check valve prevents water from returning to the system. Flooded systems (below water level) require a water trap (drain valve) to protect the system in the event that the check valve fails. To replace the check valve simply pull the delivery line off the check valve at both ends and replace with new check valve. -
Page 12: Warranty
• 5 year pro-rata warranty of chlorinator cell. (1000, 2000, 3000 Warranty series only). • 10 year (1 YEAR IN-FIELD) warranty on the ozone production corona discharge unit. Activate your Ozone Swim warranty by registering at: maytronics.com.au/support/registration WARRANTY Glass Tube 3 Year Warranty Ozone PCB 3 Year Warranty... -
Page 13: Troubleshooting
Troubleshooting Fault Potential Causes Action Required Cell output display flashing • Pump turned off or • Ensure pump is on disconnected “Pb” continuously (no water • Valves closed • Ensure correct valves are open flow) • Gas sensor wire at cell •... - Page 14 ozoneswim.com.au...