Basic components
EMU26070
Manual starter handle
To start the engine, first gently pull the han-
dle out until resistance is felt. From that posi-
tion, then pull the handle straight out quickly
to crank the engine.
EMU26090
Main switch
The main switch controls the ignition system;
its operation is described below.
"
" (off)
G
With the main switch in the "
tion, the electrical circuits are off, and the key
can be removed.
"
" (on)
G
With the main switch in the "
tion, the electrical circuits are on, and the key
cannot be removed.
"
" (start)
G
With the main switch in the "
sition, the starter motor turns to start the en-
13
gine. When the key is released, it returns
automatically to the "
ZMU03354
EMU26141
Power trim and tilt switch on remote
control or tiller handle
The power trim and tilt system adjusts the
outboard motor angle in relation to the tran-
som. Pressing the switch "
outboard motor up, then tilts it up. Pressing
the switch "
tor down and trims it down. When the switch
is released, the outboard motor will stop in its
current position.
NOTE:
For instructions on using the power trim and
ZMU04037
tilt switch, see pages 30 and 33.
" (off) posi-
" (on) posi-
EMU26151
Power trim and tilt switch on bottom
engine cowling
" (start) po-
The power trim and tilt switch is located on
the side of the bottom engine cowling. Press-
" (on) position.
ON
OFF
START
" (up) trims the
" (down) tilts the outboard mo-
ZMU03590