Steering Friction Adjuster; Power Trim And Tilt Switch On Remote Control Or Tiller Handle; Power Trim And Tilt Switch On Bottom Engine Cowling - Yamaha 40V Owner's Manual

Basic components
difficult to steer, which could result in an
accident.
EMU26122

Steering friction adjuster

A friction device provides adjustable resis-
tance to the steering mechanism, and can be
set according to operator preference. An ad-
justing screw or bolt is located on the swivel
bracket.
To increase resistance, turn the adjuster
clockwise.
To decrease resistance, turn the adjuster
counterclockwise.
EWM00040
WARNING
Do not overtighten the friction adjuster. If
there is too much resistance, it could be
difficult to steer, which could result in an
accident.
14
EMU26141
Power trim and tilt switch on remote
control or tiller handle
The power trim and tilt system adjusts the
outboard motor angle in relation to the tran-
som. Pressing the switch "
outboard motor up, then tilts it up. Pressing
the switch "
tor down and trims it down. When the switch
is released, the outboard motor will stop in its
current position.
NOTE:
ZMU03591
For instructions on using the power trim and
tilt switch, see pages 37 and 41.
EMU26151
Power trim and tilt switch on bottom
engine cowling
The power trim and tilt switch is located on
ZMU02908
the side of the bottom engine cowling. Press-
ing the switch "
motor up, then tilts it up. Pressing the switch
" " (down) tilts the outboard motor down
and trims it down. When the switch is re-
leased, the outboard motor will stop in its
current position.
EWM01030
WARNING
Use the power trim and tilt switch located
on the bottom engine cowling only when
the boat is at a complete stop with the en-
gine off. Attempting to use this switch
" (up) trims the
" (down) tilts the outboard mo-
" (up) trims the outboard