Table of Contents
Advertisement
1. Lanyard
2. Lock plate
EMU26090
Main switch
The main switch controls the ignition system;
its operation is described below.
"
" (off)
G
With the main switch in the "
tion, the electrical circuits are off, and the key
can be removed.
"
" (on)
G
With the main switch in the "
tion, the electrical circuits are on, and the key
cannot be removed.
"
" (start)
G
With the main switch in the "
sition, the starter motor turns to start the en-
gine. When the key is released, it returns
automatically to the "
" (off) posi-
" (on) posi-
" (start) po-
" (on) position.
Basic components
EMU26141
Power trim and tilt switch on remote
control or tiller handle
The power trim and tilt system adjusts the
outboard motor angle in relation to the tran-
som. Pressing the switch "
outboard motor up, then tilts it up. Pressing
the switch "
" (down) tilts the outboard mo-
tor down and trims it down. When the switch
is released, the outboard motor will stop in its
current position.
NOTE:
For instructions on using the power trim and
tilt switch, see pages 34 and 36.
EMU26151
Power trim and tilt switch on bottom
engine cowling
The power trim and tilt switch is located on
the side of the bottom engine cowling. Press-
ing the switch "
" (up) trims the outboard
motor up, then tilts it up. Pressing the switch
"
" (down) tilts the outboard motor down
and trims it down. When the switch is re-
leased, the outboard motor will stop in its
current position.
EWM01030
WARNING
Use the power trim and tilt switch located
on the bottom engine cowling only when
the boat is at a complete stop with the en-
gine off. Attempting to use this switch
" (up) trims the
15
Advertisement
Table of Contents
