Yamaha F40G Owner's Manual page 63

If the engine is warm and fails to start,

open the throttle slightly and try to start the
engine again. If the engine still fails to
start, see page 93.
EMU38640
Electric start and remote control models
EWM01840
WARNING
Failure to attached engine shut-off cord

could result in a runaway boat if opera-
tor is ejected. Attach the engine shut-
off cord to a secure place on your cloth-
ing, or your arm or leg while operating.
Do not attach the cord to clothing that
could tear loose. Do not route the cord
where it could become entangled, pre-
venting it from functioning.
Avoid accidentally pulling the cord dur-

ing normal operation. Loss of engine
power means the loss of most steering
control. Also, without engine power,
the boat could slow rapidly. This could
cause people and objects in the boat to
be thrown forward.
1. If the lock mode of the Yamaha Security
System is selected, use the remote con-
trol transmitter to select the unlock
mode. Short beep will sound twice when
unlocking the Yamaha Security System.
For further information, see page 21.
TIP:
If you lost track of the current security

mode, press the lock or unlock button to
reset the security system.
The signal transmission range of the re-

mote control transmitter varies depending
on the mounting position of the receiver.
To operate the Yamaha Security System
correctly, use the transmitter as close as
possible from the receiver.
If Yamaha Security System may not oper-

ate correctly, repeat the activating proce-
dure once again.
2. Place the remote control lever in neutral.
TIP:
The start-in-gear protection device prevents
the engine from starting except when in neu-
tral.
3. Attach the engine shut-off cord to a se-
cure place on your clothing, or your arm
or leg. Then install the clip on the other
end of the cord into the engine shut-off
switch.
4. Turn the main switch to "
5. Turn the main switch to "
Operation
" (on).
" (start).
57