Download Print this page

Advertisement

Recommended oil: We recommend the use of high quality detergent oil classified for SF,
SG, SH, SJ or higher. Do not use special additives.
Filling oil tank
-
Open the oil tank.
-
Fill directly the oil in the tank. Do not overfill.
-
Close the oil tank. Wipe any spillage.
Checking the oil level
-
Check the oil level when the engine is off and horizontal.
-
Remove the plug / dipstick from the oil tank and
wipe it off.
-
Insert the oil tank plug / dipstick into the tank
neck as shown, without screwing it in, and then
remove it to check the oil level.
-
If the oil level is near or below the lower limit of
the dipstick, remove the dipstick and fill the
recommended oil reservoir up to the upper limit
of the dipstick (bottom edge of the dipstick). Do
not overfill.
-
Replace the oil tank plug / dipstick.

5. USE

a. Starting the tool
Before starting and using the mower, check for the presence and operation of safety
devices. Also, check the condition of the blade and its securing bolt. If necessary, replace
or repair defective items. Use only genuine original parts.
If possible, mow only when the grass is dry. If the grass is wet or excessively long,
perform two cutting passes. Make the first pass at maximum cutting height to avoid
overloading the mower. The second pass should be made at the required finished height.
If grass builds up beneath the mower's chassis, stop the engine and remove the spark
plug's cap before cleaning the underside of the cutter deck.
-
Slide the throttle lever to and for several times to ensure that it is moving smoothly
and correctly.
-
Start the mower in a clear, level area. Do not start the engine if the cutting blade is
resting on rough and uncut grass as this may cause difficulties at start‐up.
-
For a cold start, move the throttle lever to the position marked: START
-
For a hot start, move the lever to the position marked: RUN
-
Stand
behind
control
lever
rearwards
so
the handlebars. Move the operator
positioned in front of the handlebars
that the lever is resting against the
11

Advertisement

loading