Table of Contents
Advertisement
Using the Control Panel
Touch anywhere on the screen to turn on the control panel.
Power
Memory
Clean Cycle
SETTING THE TEMPERATURE
A.
Press the temperature icon
set temperature screen.
B.
Press the up-arrow icon
and hold to raise the temperature continuously.
C.
Press the down-arrow icon
Press and hold to lower the temperature continuously.
OPERATING THE JETS
A.
After pressing the Jets button
pumps off (if they are on) or all jet pumps to high speed (if they are off).
B.
Press the single jet icon button
C.
Press the double jet icon button
D.
Press the off button
USING THE LIGHTING
A.
After pressing the Lights button
lights on or off. All lights will be blue when turned on.
B.
Press the left or right arrow
setting for all lights that are currently on.
C.
Press any of the color boxes
D.
Press the multicolored box
Press the color wheel a second time to stop at the desired color.
E.
Press the right-facing arrow
for additional lighting options.
For all other functions, including system mode, cleaning mode, tool
menu, locking features, sleep mode, filter cycles, and audio, please
refer to your owner's manual.
©2023 Watkins Wellness
102 ˚
F
Settings
Jets
Salt System
shown on the home screen to display the
to raise the set temperature of the spa. Press
to lower the set temperature of the spa.
, press the power button
to turn the jet pump on low speed.
to turn the jet pump on high speed.
to turn the jet pump off.
, press the power button
to decrease or increase the brightness
to turn that color on in all light zones.
to turn the color wheel on in all light zones.
to advance to the secondary lights screen
Maintenance Tips
Protect your investment for
years to come with these
important tips.
CARE FOR YOUR SPA SHELL AND COVER
•
•
•
Music
Lights
WARNING! Protect Your Spa Against Sun Damage
•
•
to turn all jet
WARNING! Filling Your Spa With Cold Water
•
to turn all
•
A soft rag should easily remove most dirt from your
spa's shell. Most household chemicals are harmful to
the shell, especially Windex or anything with citrus.
Do not allow any items, including children or pets to
sit on the cover.
Regularly clean and condition your spa cover:
–
After rinsing, a very mild soap solution can be
used: one teaspoon of dishwashing liquid with
two gallons / 7.5 liters of water.
–
Use water only on the underside of the cover.
–
If necessary, you can scrub the outside of the
cover with a soft brush, then rinse well and
condition with FreshWater® Cover Shield.
NOTE: FreshWater Cover Shield should only be
used on vinyl covers. Do not use if your spa has a
polyester cover.
Be aware of reflections
INTENSE SUNLIGHT CAN DAMAGE
from double-paned
windows shining on the
spa. These reflections
can cause severe
damage including
warped panels, a melted
cover core, and potentially even fire.
Direct sunlight on an empty spa can cause the shell to
blister. This can happen very quickly, especially with
darker shell colors. Always keep the spa cover on
when not in use.
If the water used to fill your spa is below 50° F (10° C),
the spa may go into High Limit Protection Mode and
stop functioning. If the issue does occur,
–
Disconnect power to the spa completely.
–
Warm the two
USE HAIR DRYER TO HEAT SENSORS
sensors on top of
the heater and the
vinyl tubing (located
in the equipment
compartment) with
a hair dryer for
approximately 10 minutes.
–
Reconnect the power to the spa.
You may also resolve the issue by blending warm
water into your cold fill water to raise the temperature
above 50° F (10° C) during the refilling process.
☼
10
MINUTES
PN 63696 • Rev. A
Advertisement
Table of Contents
