Operation - BorMann 019183 Manual

EN
Assembly
Important: Always disconnect the tool from the mains before carrying out any assembly or adjustment work.
Changing the blade
Bolt
Outer flange
Inner flange
Saw Blade
Warning: Always disconnect the plug from the power mains before making any adjustment or attaching any accessories.
1. Place this circular saw on its side on a flat surface. Advice you bring the base plate down as a minimum depth cut then it is ease to change the blade.
2. Push the spindle lock button (no show) toward motor housing as the arrow shows in fig. 3 and firmly hold it.
3. Turn the blade clamp bolt (3) anti-clockwise by using the wrench that supplied with the tool.
4. Remove the blade clamp bolt (3) and outer flange (2).
5. Raise the lower guard (5) by using the lever for lower guard (6), and then remove the saw blade.
6. Clean the saw blade flanges, then mount the new saw blade onto the output spindle and against the inner flange.
7. Make sure the saw teeth and arrow on the blade is to be the same direction as the arrow on the lower guard.
8. Reinstall the outer flange, and tighten the blade clamp bolt.
9. Make sure that the saw blade runs freely by turning the blade by hand.
Angle adjustment
1. Loosen the Lock knob for angle adjustment (9).
2. Adjust the shoe to the desired angle between 0°to 45°. [See miter scale (8)].
3. Tighten the lock knob for angle adjustment.
Switching on and off
Before engage the ON/OFF switch, check that the saw blade is properly fitted and run smoothly, the blade clamp bolt is well tightened.
1. Plug the cord set into power socket.
2. To start the tool by pressing the switch trigger (11).
3. If you press the lock-on button (10) while the trigger is pressed, the trigger is kept in the operating position for continuous operation.
4. To release the trigger and turn the tool off.

Operation

General cutting
1. When starting, always hold the saw handle with one hand and the auxiliary handle (6) with the other hand. Never force the saw but maintain a light and
continuous pressure after completing the cut allow the saw to come to a complete stop. When cutting is interrupted, resume cutting by allowing the blade to
reach full speed and then reentering the cut slowly.
2. When cutting across the grain, the fibers of the wood have a tendency to lift and tear, moving the saw slowly minimizes this effect.
5
Depth Adjustment
1. Loosen the lock lever for depth adjustment (8).
2. Hold the baseplate flat against the edge of the work piece and lift the body of the saw until the blade is at the right
depth determined by the depth of cut scale () (align the scale line).
3. Tighten the lock lever for depth adjustment.
WWW.NIKOLAOUTOOLS.GR
Socket
Wrench