Detailed Component Operating Instructions - Intellifire - Hearth & Home Majestic MDV3732 Owner's Manual

J. Detailed Component Operating Instruc-
tions - IntelliFire
IntelliFire Ignition System
®
IntelliFire, an ignition system exclusively featured in
Hearth & Home Technologies products, is an energy-
saving pilot ignition system for gas fireplaces and inserts.
It provides an ignition flame only when needed and has
a battery backup system that supplies power to spark the
ignition flame in the event of a power outage.
Intellifire is an intermittent pilot ignition, which is an
electronic system. The term Intermittent is used because
the pilot burner flame is only present when the main
burner is operating. When the main burner is off the pilot
is also off.
NOTICE: Batteries should not be placed in the battery
pack while using the transformer. Remove batteries before
using the transformer, and unplug the transformer before
installing the batteries. Battery polarity must be correct or
module damage will occur.
Fan
The MDV3732-C comes standard with a factory-installed
fan. Heat management for the fan is discussed in Section
3.H. Detailed instructions are included with the fan kit.
14
®
Hearth & Home Technologies • MDV3732-C Owner's Manual • 2552-981 Rev. F • 1/20
Appliance ON/OFF
The MDV3732-C comes standard with a factory-installed
SMART-STAT remote control. Refer to SMART-STAT
information included in Section 6.C.
To operate the appliance without a remote control, an
ON/OFF switch may be installed and located inside the
control cavity of the appliance. See Figure 3.7. The
decorative front must be removed to access the control
cavity.
CAUTION! Risk of Electric Shock! Avoid touching wires
and electrical components in appliance control cavity.
ON/OFF SWITCH SECURED
TO VALVE BRACKET
Figure 3.7 ON/OFF Switch Location
ON/OFF
SWITCH
CONTROL
CAVITY