Operation During A Power Outage (Ipi) - Hearth & Home Majestic MDV3732 Owner's Manual

I. Operation During A Power Outage (IPI)
The IntelliFire intermittent pilot ignition system comes
®
with a battery backup system that enables the system
to operate in a power outage. A factory-installed battery
pack is located in the control cavity of the appliance. See
Figure 3.5. Batteries should not be placed in the battery
tray while using electrical power to operate the fireplace.
Remove batteries from battery tray when power has been
restored.
NOTICE: Batteries should only be used as a power source
in the event of an emergency power outage. Batteries
should not be used as a primary long-term power source.
To Operate Fireplace Using Battery Power (DC):
1. Access the control cavity of the appliance. See Figure
3.5 for location. The decorative front or door may
need to be removed.
2. Locate the battery tray and insert two D cell batteries.
Battery polarity must be correct or module damage will
occur. A complete wiring diagram is included in the
Electrical section of the Appliance Installation Manual.
3. Turn the appliance on according to the instructions
below for the factory-Installed Remote Control
(SMART-STAT) located in Section 6 of this manual:
• Locate the remote receiver in the control cavity of the
appliance.
• Slide the switch to the ON position.
NOTICE: Some functionality will be lost when using battery
backup including remote control, fan, or any other auxiliary
functions that require household 110-120 VAC power.
To Return to Operation Using Electrical (AC) Power:
Factory-Installed Remote Control (SMART-STAT):
• Locate the remote receiver in the control cavity of the
appliance.
• Remove the batteries from the battery pack.
• Slide the switch to the REMOTE position. See Figure
3.6.
Hearth & Home Technologies • MDV3732-C Owner's Manual • 2552-981 Rev. F • 1/20
REMOTE RECEIVER
Dry Contact
(2) 1/4 in. female
connectors
Learn
Figure 3.6 Remote Receiver
110VAC
Input
ON
REMOTE
OFF
Antenna

13