Removing The Device - ADS-tec OPD9016 Instruction Manual

OPC9000 series − Instruc�on manual v1.5

10.1 Removing the device

ATTENTION
Depending on the installation situation, have a person hold the front of the device, if needed to
prevent it from falling down after the clamps are loosened.
1. Loosen the clamping screws by turning counter-
clockwise (5 mm hex socket).
2. Push the clamps completely into the housing
against the spring pressure.
3. Tighten the clamping screws counter-clockwise
as far as they will go, so that the clamps are
fixed in the housing and do not prevent the
device from being removed from the wall recess.
4. Remove device from the wall recess.
© ads-tec Industrial IT GmbH • Heinrich-Hertz-Str. 1 • 72622 Nür�ngen • Germany
42