Device Installa�On - Sequence - ADS-tec OPD9016 Instruction Manual

OPC9000 series − Instruc�on manual v1.5
4.5 Device installation – Sequence
1. Depending on the orientation of the device, loosen, for example,
the left and right clamp by turning the clamping screws clockwise
(5 mm hex socket).
The clamps will protrude slightly from the housing due to spring
pressure.
CAUTION
Personal injuries and damage to property
due to the unit falling down
If the clamps protrude more than 5 mm (e.g. 15 mm),
they are disengaged and can no longer bear
mechanical loads.
•
Make sure that the clamps do not protrude more
than 5 mm.
© ads-tec Industrial IT GmbH • Heinrich-Hertz-Str. 1 • 72622 Nür�ngen • Germany
19