So�Ware / Driver Installa�On; Ini�Al Installa�On Of The Opera�Ng System; Write Protec�On; Installing The Netjack Modules At A Later Stage - ADS-tec OPD9016 Instruction Manual

OPC9000 series − Instruc�on manual v1.5 40
8 Software / driver installation
8.1 Initial installation of the operating system
The devices are delivered with a pre-installed operating system depending on the client's specifications.
If the mass storage has been reformatted, the operating system can be reinstalled by using one of the
existing interfaces (alternatively via USB or PXE).
The files required for this (image, driver and firmware), along with a detailed description of the
procedure, can be obtained from ADS-TEC support on request.
8.2 Write protection
protection must be removed again before changes are made to the software installation. ⇨ Unified Write
If the mass storage or parts of it have been write-protected in the Configuration Center, this write
Filter
After the software installation has been changed, the write protection must be set again and the device
restarted.

8.3 Installing the netJACK modules at a later stage

If these modules are installed later, a driver must be installed, which is located in the following directory:
C:\Drivers\Fieldbus\Hilscher
Start the cifX Device Driver Setup.
After successful installation, the device appears in the device manager as cifX Communication
Interface.

9 Cleaning

Clean the device using some glass cleaner on a soft cloth.
© ads-tec Industrial IT GmbH • Heinrich-Hertz-Str. 1 • 72622 Nür�ngen • Germany