Led; Toggle Switch And Push Switch; Variable Resistor - Renesas RX200 Series User Manual

Renesas RX Family
5.1.6

LED

The INV-BRD has three LEDs which the user can control. The LED ON/OFF is controlled by the pin state.
5.1.7

Toggle switch and push switch

The INV-BRD has toggle switch (SW1) and push switch (SW2). The pin voltage is controlled by the state of
them.
5.1.8

Variable resistor

The INV-BRD has a variable resistor (VR1). If turning the variable resistor clockwise, terminal voltage of the
variable resistor (CN3-17) becomes low. If turning it counterclockwise, the voltage becomes high.
R12UZ0111EJ0100 Rev 1.00
November 15, 2022
Table 5-2 LED
Connector pin LED1
CN4-18
HIGH OFF
LOW
CN4-19
HIGH
LOW
CN4-20
HIGH
LOW
Table 5-3 Toggle switch and push switch
Connector pin
CN4-16
HIGH
LOW
CN4-17
HIGH
LOW
Table 5-4 Variable resistance specification
Item
Input voltage range
Variable resistor range
MCK-RX26T User's Manual
LED2 LED3
‐ ‐
‐ ‐
ON
‐ ‐
OFF
‐ ‐
ON
‐ ‐
OFF
‐ ‐
ON
SW1 SW2
‐
ON
‐
OFF
‐
RELEASE
‐
PUSH
Specification
0~AVCC
0~10kΩ
Page 24 of 38