Page 1
FIXED MANUAL The Electric HiLo Combo foundation elevates the head section up to 70°, the knee sections up to 35° and elevates the foundation/mattress up to 10”. Operates by corded remote control. SleepSafe ® (Low Bed) SleepSafe ®...
Component Chart #1 Assembly Component Chart #2 Mattress Information Safety Rail Adjustment Instructions 6, 7 Assembly Guide: SleepSafe Low Bed SleepSafe II Medium Bed Allen and Torx Wrenches 8, 9 Assembly Guide: SleepSafer Tall Bed (Supplied) SleepSafer Tall Bed Dual View...
Page 3
• NEVER USE THIS BED IF THERE ARE ANY SPECIFICALLY DESIGNED AND FITTED FOR MISSING FASTENERS, LOOSE JOINTS, A SLEEPSAFE® BED AND ITS USER. BROKEN PARTS, TORN MESH, OR PADDING INADEQUACIES. CONTACT SLEEPSAFE BEDS AT 866.852.2337 FOR ASSISTANCE. SleepSafeBed.com | 866.852.2337...
Page 4
Included Components Assembly Cardboard Lift 90 mm Allen Bolt 3/4” Hex Bolt Barrel Nut (If the bed is unpadded) Safety Rail Hinge Guard Assembly Allen / Torx Wrench Set (3 sizes) Square Bit Driver Casters (Attached) Extension Bed Safety Latch &...
Page 5
Included Components Assembly Electric Hi-Lo Frame Mattress Headboard Footboard Side Panel Front Panel Back Panel Safety Rail Extension End Panel Extension Bed Side Panel Extension Bed SuperScreen...
SleepSafe Bed Mattress Information SleepSafe Bed® – Our Specialized Memory Foam Mattress Matttress Cover with Gel Technology SleepSafe® Bed mattress support surface provides optimized pressure redistribution, rapid heat dissipation, and increases breathability compared to standard foam. • Reduced incidence of pressure...
Page 7
Safety Rail Adjustment: Up and Down Does the Safety Rail Additional Tools Needed: POST Hammer or Mallet need adjustment? Portable Electric Drill For proper operation, the pin should be centered in the strike. If not centered, follow these steps to center the pin in the strike.
Align and push in Barrel Nut as shown. Use flathead SleepSafe Bed (Low Bed) Side Panels use 8 Barrel Bolts screwdriver for SleepSafe II (Medium Bed) Side Panels use 12 Barrel Bolts assistance. Attach Side Panels to foundation.
Page 9
Do not substitute the mattress as it designed specifically for Install Mattress. SleepSafe® Beds. Further information is available on Page 4. Install Safety Rails Step 1 When safety rail is in the down INSERT the hinge pin into the...
Page 10
SleepSafer (Tall Bed) Assembly Guide SleepSafer (Dual View) After unpacking bed and checking the contents Set HiLow Foundation on 4 provided cardboard lifts. When placing cardboard lifts beneath foundation, allow room for both side panels to be attached. Save cardboard lifts for future use! ...
Page 11
Do not substitute the mattress as it designed specifically for Install Mattress. SleepSafe® Beds. Further information is available on Page 4. Install Safety Rails When the bottom safety rail is in the down position, insert the hinge pin into the headboard strike, then slide the hinge pin into the footboard strike.
Page 12
Assembly Guide SleepSafe ® Extension Bed (w/SUPERSCREEN Top) After unpacking bed and checking the contents Set Extension Side Rails Upside Down and on their Legs. Legs are upside down. Assemble this with two people, otherwise one person can assemble one panel at a time after the the rest of the bed is assembled.
Page 13
This SleepSafe® Extension Bed installation step is based on ordering it as a complete unit. Retrofitting an extension to a SleepSafer® Tall Bed Loosen top requires additional instructions. bolts on all 4 bed posts. This allows play in the frame to fit the Extension.
SleepSafe Bed Padding Information Materials: • 70 Denier Nylon Fabric Cover with a Fluid Resistant Healthcare Coating • 3/4” High Density Foam Padding Padding Features: The safety rail pads extend up and over the rails and attach to the outside of the safety rails.
The mattress should always fit snugly against the sides. If not, contact the DME or Customer Service at SleepSafe Beds. Check Bed Operation Knee should move up to 35° with the Remote.
AND BE SURE THAT BOTH SIDES ARE SECURED ON THE POSTS. The top Safety Rail on the SleepSafer ® (Tall Bed) is removable. The top Safety Rail on the SleepSafe Extension Bed ® is not removable because it flips up and latches onto the extension.
Page 17
My child’s medical needs have changed. Can I change the foundation? Yes. Most SleepSafe ® Bed foundations can be converted to another bed. To convert a SleepSafe Bed foundation, you will need to purchase a Conversion Kit from SleepSafe Beds. Insurance may or may not cover the additional ®...
Limited Five Year Warranty for SleepSafe® Bed Mattress During the second to fifth year, SleepSafe® Beds, LLC will replace the mattress due to a defect in the materials or workmanship of the mattress, with the shipping costs to be paid by purchaser.
DME Address ____________________________________ DME Phone ____________________________________ DME Email ____________________________________ Installed by ____________________________________ Customer Service & Technical Support SleepSafe Bed Support DME Provider Support Hours: 8 AM to 5 PM / M-F / EST DME: ________________________ Toll Free: 866.852.2337 Local: 276.627.0088 Conact: ______________________ Fax: 276.627.0234...
Page 20
SleepSafeBed.com | 866.852.2337 3629 Reed Creek Drive | Bassett, VA 24055 | FDA Registered WI-820.120-7 Electric Hi-Lo Combo [7] Rev. 05...
Need help?
Do you have a question about the SleepSafe and is the answer not in the manual?
Questions and answers